Email required Address never made public. The instructions are duplicated here for quick reference. You are commenting using your WordPress. Select Turn User Account Control on or off. Open the Control Panel. Fill in your details below or click an icon to log in: On Windows XP, if you get the following message while updating the driver:

Uploader: Grojin
Date Added: 27 May 2008
File Size: 5.61 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61993
Price: Free* [*Free Regsitration Required]

With the old PC I have not tried to build any designs or run any simulations yet, but the machine should be able to handle it, perhaps pirt slowly though.

After it opens, I like to close all of the open windows in the GUI and start fresh, as shown below. So I decided to go with option number two and bring my old PC back to life. By continuing to use this website you consent to the use of cookies as described in our Cookie Policy. For the USB programming cable, note the the names of the different wires, and then use the QuickStart guide to match the wire name to the right pin.

Lattice Semiconductor

Portt the cable is connected correctly, supply power to the XP2 board and launch ispVM. By continuing to use this website, you agree to their use. Before creating a simple design and programming it to the device, there is one more critical step that requires attention: And that shall be the topic of the next post!


About Us Who is Lattice? This site uses cookies.

XP2 Board: JTAG scan with ispVM | The Global Engineer’s Notebook

The instructions are duplicated here for quick reference. You are commenting using your WordPress. For the parallel port programming cable supplied with the XP2 Brevia Kit, just follow the directions in the QuickStart pagallel.

With both the serial port verified with the paraallel program and the JTAG scan completed, the basic connections to the outside world are verified. The amount of time will vary, depending on your PC’s speed.

To select the parallel port cable, manually select the Lattice cable from the Cable Type drop-down list.

As expected, the device is visible and we have also gained some basic familiarity with the ispVM tool. Use the ispVM cable auto detection to determine which cable and port you are using. You are commenting using your Facebook account.

Notify me of new comments via email.

JTAG is an simple interface used for testing silicon devices on a circuit board, and it is also a common interface for programming FPGAs during the design and testing phase in the development cycle. Click on the Driver tab and click on the Update Driver button.


XP2 Board: JTAG scan with ispVM

To find out more, including how to control cookies, see here: We also allow third parties to place cookies on our website. Be sure to turn off the target board’s power before connecting or disconnecting the USB cable to the target board. Technical Support Need Help? Fill in your details below or click an icon to log in: Follow the steps to update the driver.

Leave a Reply Cancel reply Enter your comment here Like most websites, we use cookies and similar technologies to enhance your user experience. In the dialog box, click Auto Detect. Skip to content Home XP2 Board: If more than one USB cable is connected to your PC, the ispVM System software will detect all available cables, but it will select the first cable it detects. You are commenting using your Twitter account.